Best Tool For Removing Carpet Tack Strips

Then tap it with a hammer until the tack strip pops up.

Best tool for removing carpet tack strips.

The installer needs a gap at least 1 4 in. Press the pry bar in order to begin lifting the tack strip. At those points slide a pry bar under the tack strip. Carpet tack strips can usually remain in place but look for rust rot or other damage.

Pick somewhere to start either a corner or a break between two tack strips. Once the carpet is removed locate the nails which attach the tack strips to the floor. Some people have a hard time with this step but i ll show you how to remove carpet tack strips the easy way with three simple tools. Begin at the top of the stairs.

Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced. Rust can bleed through the carpet creating stains on the surface. Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips. Pull the pry bar free and remove the putty knife if you re using one.

Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish. To remove tack strip just pop it up with a flat pry bar. Reinsert them beside the next nail on the tack strip and pop that nail out the same way.

Roll or fold the strip secure with duct tape and remove it from the room. If you are pulling up carpet from stairs. You should also remove the tack strip if it s less than 1 4 in.